Getting the most out of my 360

Toss in some KB-107's too, 10.6:1, you gain somewhere around 30 hp/tq. You can get them and a set of moly rings on ebay for around $300.

Set ring gap to largest forced induction spec in case you ever want to juice it, no you don't have to buy file fit to file them down, set up a square file in a vice with some tape to guard the edges and file towards the inside of the ring, never back and forth.


Balance and square decking is highly recommended and should run fairly cheaply.



Also check dynamic compression ratio by adding your cam's ADBC, intake closing, to the rest of your information here:

http://www.wallaceracing.com/dynamic-cr.php

Folks say if you keep at or below 9.0 on those modern, fast burn closed chamber heads and good quench, you can run 89 all day, 87 in a pinch.