Pushrod Length

OK, as I wrote these numbers earlier in the thread I kept thinking that they didn't seem right. I pulled up my sheet where I recorded the numbers and here is what I got:

Low: 6.775
High: 6.7825

My notes show I used .040 for lifter preload and used the higher number for push rod length.

6.7825+.040 = 6.8225"

I found a Comp Cams pushrod at Summit that was 6.821" on the shelf and when with that.

The new push rods I ordered were 6.845", so the new preload should be 6.845 - 6.7825 = .0625"

I hope it is not too much.