Biohazard
Disassembled the doors for proper washing, a lot like how I did the floors, i.e. soapy water, scrubbing, and ample rinsing because I specifically went for the space between the inner and outer door skins.
Driver's door, shown with vapor shield removed and most of the tape peeled off (near the bottom), before washing.
Inside the door. Looking pretty good here, just dirty. Its going to take a skinny brush to get down in that crease at the bottom.
Going all-out to get it done. Sprayed the entire inside with a cleaning solution and hosed it out with a vengeance. Good thing there's drain holes at the bottom.
Door washed. I sprayed some Krud Kutter along the adhesive tape and let it soak, hoping it will peel off a little easier.
Otherwise, the door handles are in a very good state, needing just a light polishing to bring the bling back and the armrests are likely cleanable but, if not, repros are available in white so...whatever.
Disassembled the doors for proper washing, a lot like how I did the floors, i.e. soapy water, scrubbing, and ample rinsing because I specifically went for the space between the inner and outer door skins.
Driver's door, shown with vapor shield removed and most of the tape peeled off (near the bottom), before washing.
Inside the door. Looking pretty good here, just dirty. Its going to take a skinny brush to get down in that crease at the bottom.
Going all-out to get it done. Sprayed the entire inside with a cleaning solution and hosed it out with a vengeance. Good thing there's drain holes at the bottom.
Door washed. I sprayed some Krud Kutter along the adhesive tape and let it soak, hoping it will peel off a little easier.
Otherwise, the door handles are in a very good state, needing just a light polishing to bring the bling back and the armrests are likely cleanable but, if not, repros are available in white so...whatever.