No criticism here, just observation. When I saw the conduit on the driver side for the first time it looked kinda ugly going around that structural piece. Not that I could have done better, but it seemed like an experienced electrician could have used a pipe bender to make that kink. I was an electrician's apprentice once upon a time, and tube bending was always a mystery, There were folks who could make a couple of measurements, bend the pipe on the ground and hang conduit runs that were like works of art.
Then I saw the conduit on the passenger side and noticed the kink looked much smoother, like you HAD bent the pipe - much better IMHO! But then came the welding discussion. If that passenger side is welded, not bent, you do mighty fine welding!
Great thread, and mighty nice project!!
BC
