*HELP* best way to cut/assemble SS braided fuel line ??**

this is my first time working with this stuff >> need some help PLEASE ...
just looking for some tips/advice on the best way to cut/deburr the SS braided fuel line so it assembles into the -AN hose fittings well ...
* i tape the section to be cut, and then cut through the tape to try and minimize the braid seperating ..
* i have tried a fine-tooth hack saw
* i have tried a cut-off wheel on a die grinder

no matter how careful i am when cutting, the SS braiding seems to unravel/spread enough to make it virtually impossible to squeeze into the ID of the fitting; not to mention the fact that it rips the end of your fingers up :) ... i have tried to snip off the frayed pieces, but that doesn't go very well ..

any help from people that have done this often and have found a way that works well for them will be GREATLY appreciated ...

thanks