Twin Hood Scoop Templates for 70-71 Dart - Anyone have one?
Saaaweeettt! Thank you so much.
Question - when drilling holes what bit do you use? Place tape on hood placement, mark tape and then drill down?
From Tazz original post -is this what works best?
The longest part of this install was the aligment of the template (want to make sure it's right) and the marking of the holes. Once that was done it only took about 15 minutes to drill out the rest of the holes after predrilling everything with a 1/8" drill bit. I used a unibit to drill out the 3/8" & 1/2" holes. And if your not going to drill out the 4 1/8" hole heck that cuts the time in half. What takes time is that your getting ready to drill some holes in perfectly good hood. Kind of scary but the rule is measure twice cut once. same applies here.
Sorry if questions are stupid. Really nervous about drilling a newly painted hood.
