My '68 Fastback 4 speed swap
I know it's ugly. But I'm not painting it, LOL. That's how I got it, it was painted and done.
I did however, cut out my floor for the tunnel, installed the engine and trans for mock up. The floor tunnel fits nicely. I pulled the plug in the inner fender, installed the ball stud and test fitted the Z-bar. Lines up good.
Tomorrow I will install the pedals, take the engine/trans back out, install the clutch and flywheel, and mess with the clutch linkage.
Do yall happen to know the torque specs for the clutch and flywheel? Same as it says in the book? Shall I use red loctite as well?
I know it's ugly. But I'm not painting it, LOL. That's how I got it, it was painted and done.
I did however, cut out my floor for the tunnel, installed the engine and trans for mock up. The floor tunnel fits nicely. I pulled the plug in the inner fender, installed the ball stud and test fitted the Z-bar. Lines up good.
Tomorrow I will install the pedals, take the engine/trans back out, install the clutch and flywheel, and mess with the clutch linkage.
Do yall happen to know the torque specs for the clutch and flywheel? Same as it says in the book? Shall I use red loctite as well?
