I am using a push button start. Again when I push the bush button it starts up but when I let it go the car just dies. The run button that is connected to the Ballast is 12v + but when I Check the volt on the start side there is no power there. It is not dropped down to 6-7 volts there are no volts at all. So when I push the button 12 volts go to the coil and starts but when I let it go for some reason the run side is not pushing volts to the other side of the ballast. Maybe the ballast is bad? The car starts up fine when I by past the ballast but the coil is getting way to hot and when I used my volt meter on the coil it shows like 13+volts going into a 12volt coil.