Looking for a few things...

DarcCuda66 said

For a 66 Cuda:

Original working horn
Headliner rods(bowties?) and other parts (I'm missing it all so I'm not sure what all I need there)
Rear driver side window regulator+handle
Headlight buckets and trim rings
Windlace/Weatherstripping for both doors (or advice on where to get it)

Thanks FABO guys!

Click to expand...

you can go a couple of different way here. $130.+ for factory correct
or $2-3 a foot from a different supplier. look up pinchweld seals
I just googled it an there's the first hit that looks close
http://www.jenkinsrubber.com.au/?stg=62

I know I did mine first time with 5/8th bulb seal and it was too big(it held the door out in the closed position about 3/16th of an inch at the door latch side). I ordered 20 ft of 1/2 and it fit MUCH better. 10ft(about 8.75 really) per door for a convertible so a hard top should be similar in length.