Natasha the 68 Dart

i found a method that is really going to work with filling the holes

at first i looked into nails but one had a head too small and one was too big ...could not find the right size ....plus i was worried about welding on galvenized stuff, i know you are not supposed to do that.

then i remembered that my cousin gave me a piece of carbon for this purpose.....a strange item that i have no idea where he got it from ....he wont tell me either :sad5:

so i tried with the carbon and the first hole was kinda choppy ...i had the welder set on low bcoz i was scared to give it some power.

then i set the welder heat higher to C setting ...this is a 110 V and on C setting the plug weld layed down flatter.

after grinding and more sanding it looks like nothing was there ...it left a slight low spot on three holes so far on the driver fender ...i started with the driver fender bcoz i know it needs body work.

so far so good except it was time consuming ...one hole took 20 mins start to finish ........took a lot of patience to keep the heat down .....so i found a method that is going to work but i can see that i am going to be here for a while. :toothy9: