TTI Instructions

I have the TTI step headers, 3" X-pipe and DynoMax Ultraflo mufflers ending just before the rear end housing. I installed those big hangers off of the seatbelt mounts. They clamp onto the exit end of the mufflers. I don't have rear seatbelts in the race car, but I used extra-long bolts from the inside, have a very tight jam-nut underneath, and end up with a "stud" on each side to hang the brackets off of.

I found this: [ame]http://www.ttiexhaust.com/PDF/XA_MW6769-CUE.pdf[/ame]

There may be a slight difference between bolt locations in early & later A-bodies because I had to bend my brackets a little for a better fit. It should be possible to retain the seatbelts, if needed doing it this way as well.

I'd take pics but it's been raining here.