New distributor/elelctronic ignition/coil

Hi guys

Thanks for the knowledge shared, I think I'm good to go ahead with the install now. Just to clarify, my distributor is original from factory, the coil may have been replaced in the past.

I'll just accept the fact that the RUN wire is 12v on coil positive and just go from there.

Still puzzled about the ohm reading on the old coil, especially because I found out the 12v RUN wire has a label "resistor cable"... But theres no ballast anywhere. Not sure what this is, not making much sense to me...

It's interesting that the 1969 Brazilian darts (like mine) did not come with an ecu nor a ballast resistor. Did all American darts come with these from factory?

Cheers!