needed: WIRING DIAGRAM FOR MOPAR ELECTRONIC IGNITION CONVERSION

Ok, seriously now:


View attachment Ignition_System_5pin.jpg

View attachment Ignition_System_4pin.jpg

View attachment Mopar_Electronic_Ignition_diagram.jpg


The black/yellow wire goes to the coil - (negative).

The blue wire goes to the input side of the ballast. Easy way to find is to unplug both connectors from the ballast resistor, then turn the ignition key to the "run" position. Hook the clip of a test light to a ground and poke the pointy end into the connectors that you unplugged. The one that lights up is the input side. If you go to a NAPA store, they carry a "piggyback" flat terminal on their electrical wiring display. If you crimp that to the end of your wire from the harness, you put that on the ballast resistor first, then "stack" the original single connector on top of that. It's easy, clean, and simple to remove if you ever have the need to.

The green wire gets cut off the harness.