window frame advice needed.

Cool. I would double check to make sure the clips fit in a couple spots. Check (just hold them in place) that they will fit along the A pillar and the bottom channel of the rear window. The A pillar is "short", and the bottom of the back window location isn't as tall as the channel running up the C pillar and around the top of the window, therefore you wanna make sure they will sit flush to the car, while at the same time allowing the top of the clips to be recessed down in the channel. You don't want top of the clips sitting flush to, or above the opening, otherwise the trim will not sit tight to the gasket. This was the case on mine.
I hope that made some sense....

Let's check in a week or so about installing.