help needed bad ASAP!

Thanks for that diagram. OK here is another thing. My old wiring used all for terminals on the resistor. I picked up a new engine harness that only has 2 connectors for the resistor. Right now I have the center blue wire from the control module to the lower or right side of the U on the resistor. Opposite what is shown above. I then have my coil + wire to the terminal on the same side far end of the resistor. This has a ohm reading of 1.6 judgeing by the diagram above I'm on the compensating resistor. Is that correct?

Can I just install a 2 wire resistor and use the 5 pin module? Would that take car of the issue. Sorry if I'm making this more complicated than what it has to be.