EZ Wiring Mini 20 Circuit Installation

Thanks Bill for yours advice I forgot that you recommended me that.

Now the car is done and everything seems to work except when I try start the car. The car starts in start position but stops when the key is released to run position. I have connected everything like the EZ manual shows but the EZ harness use the start feed from the start relay instead of the brown wire. I have tried different things but doesn't make it work.


This picture shows how you should connect the wires. EZ ignition switch conversion shows that the brown wire that's only have power when the key is in start position should connect to the Pink wire which is the Pink coil positive wire in the right diagram. That doesn't make sense since in start postion utilise the power from the start relay already. So when the key is released to run position it should have power on the Pink wire so I switched the brown and blue wire so it have power in run position but it doesn't work either. Some one have any suggestions?


Thanks FABO