65 Cuda project**Must abandon :'(

-
Status
Not open for further replies.
I will be in Chicago visiting my daughter and son-in-law from July 25 to July 28. I can give a hand on the 26 or 27 if things get underway by then.
 
Ok, I spoke with Shannon tonight. He's real excited to see if we can finish his project for him to keep and drive. I am going to try to go up to meet him within a week and see where we sit. I will keep you posted.

Any volunteers post up here and let us know what you are bringing to the table. We definately need someone with body work experience to help us get the body panels installed. He has a welder that we can use.
 
Krazykuda came by my place today to check out the project, basically all I have is the shell with a bare 340 block, 727 torqueflite trans, bare dana 60 housing that's been narrowed, I also have all the trim and glass, it needs a lot of metal work, floor pans, quarter patches, wheel tubs, rear cross member, torque boxes, sub frame connectors, but I have all the replacement panels needed, just need to get it done, I also have a nice mig welder.
I just wanna say Thank you to everyone for all the kind words and all the help in turning my dream into a reality that I was ready to give up on.
Thank you everyone,
Shannon
 
Good luck bro. Make sure you post anything you might need some of us will gladly pitch in if we can.
 
You guys are great for trying to help him out. That's one of the greatest things I've ever heard. If I were near I would help if I could. You guys rock!
 
Status
Not open for further replies.
-

Back
Top