Need formula s badge location measurements

These are some notes I have on this subject.

I have the formula for the S emblem locations using linear referencing and dynamic segmentation. example: use this picture below. I used a lot, and hope you have more to check this against as one was off, but probably aren’t correct either.
http://www.rkmotorscharlotte.com/in...arracuda-Formula-S/131043/image_details?pos=7
now I know two points at least that are going to be the same nearly every time. the antenna mast and the pentastar emblem. take a piece of paper or a straight edge I used a small tape measure and measure the base of the antenna to the center of the pentastar you’ll notice the F/S emblem is dead center between them.

we have a second and third reference the bottom ridge of the fender. measure from the pentastar to the upper ridge then between the F/S and the ridge. add subtract the difference.

We also have one more side to side from fender lip to corner end of fender using the F and A from the word formula see attached picture.

To weight the thought I used a right fender I have with the V8 emblem and removed it I measured from the pentastar center to each v8 emblem hole they are exactly the same distance 6-3/8” center to center. what I came up with is from the center of the pentastar to bottom FS emblem stud is 4-1/2” and 6” exactly to top stud. which should put the bottom of the emblem circle to the ridge at 1-3/8 in” now we have our center point with references. I figure it’s +/- 1/8” and to me an acceptable tolerance.