Windshield Mylar install Question

Put my glass in yesterday (front & back). This is deffinatley a 2 person job and thanks to the help from Tadams on the board we were able to do them both in about 5 hrs total. I used a 1/4" nylon rope to help install it a flexable sealant on the body side and a urethane type sealant on the glass side to insure a good seal. The front was pretty straight forward but the rear had some tricky angles and took some time to get it in place. I waited to install the Mylar locking strip till after the glass was in place, and with the tool listed above and some spray can window cleaner it went on with a little prying. The lock strip went around all the corners exept for the rear corner near the trunk. The old gasket had a right angle clip to connect the ends around this corner but I just cut a 45 degree notch in the Mylar and filled the cracks with silcone and it seam to do fine. It was a bit messy using the sealant but witha rag and some mineral spirits it was an easy clean up. A glass shop quoted me over $300 to install just the front windshield (others wouldn't do at all) alone! I'm glad I did this myself! (with a little help!):D