65 Barracuda Gasser + 1956 325 Dodge Hemi Build

Received the radiator from the UPS man today, so we spent about 2 hours fittin' and fabbin' to get the right placement and fit. Put water in her and away we went. Quickly discovered all the bolts we missed with sealant.......weeping water from a few places. These old hemis have a ton of bolts into water passages.
Rob did a great job of fabbing up the adaptor brackets for the new radiator and without much hassle it is in and lookin good! You can see that the new radiator (bottom) outlet just barely fits beneath the front spring crossmember....whew!
FYI: I found this all aluminum radiator, after a bit of searching, that was nearly a direct bolt-in. It is a three row with some great looking tig work on it......for under $170.00 shipped to the house...not bad.
Here are some pictures from today.
I shot a 4 minute video too but I can't seem to get it to load on the video section.....anybody know how to make a video into a "URL"?
Best, Chip