Headers or Manifolds for a 67 4spd Cuda

I used B body headers on my 70 Dart with a 383 auto. Used the shumacker conversion mounts. I followed the instructions on bigblockdart.com. I made the small dings in them where they show to make. It is a very tight fit. Also take loose the steering linkage and tie rods to make it easier to slide them in. I am not sure with the 440 they will work. It is an inch taller on each side. You can look at the pictures I have posted in the restoration section on here under 70 dart swinger 383.

In a few years when I pull the motor to stoke it I will get the shumaker tri y headers easier install and better accesss to the starter. I even have a mini race starter on the car and it is very tight.

If you can mount engine and tranny on k member. And install from underside (setting body over it like at the factory) it would be a lot easier job.