Need cam suggestions

Alright well after two and a half years into the bcuda I am drawing close to the finish line. I have completely finished the body and paint(never will I start with a body that bad haha), and I have pretty much finished the short block. My next buy is going to be the cam. I have a 92 roller LA 360 that is freshly machined and bored 30 over, probe forged flat top pistons, scat I beam rods, stock crank polished, RPM air gap intake, 8 3/4 rear with 3.23, and a 3000 stall converter. It has been balanced and ready to be assembled. I still plan on topping it off with a set of Eddie RPM heads and a 750 demon. I'm looking to get at least 425 horses. Which cam should I go with without breaking the bank? Thanks :prayer: