PRW,Don't do it!!!!

I'm with Tubtar on this one. to the OP, I'm not knocking you for working on a budget, I have to myself. However, I take the same position as Moper. I don't have the money to rebuild an entire engine over the fact that I tried to save a little, and ended up with a junk piece. I just bite the bullet, and buy the high quality stuff, EVEN if I have to wait until I save a little more money.

I hate that you had close to $500 in the PRW units, because I run the same Harland Sharp needle bearing set up as Tubtar, and I only have $115 more in them than you do the PRW stuff. bought the complete set up, with the arms, hardened shafts, spacers, and adjusters for $615. the best part is that Harland Sharp will inspect your rockers for wear, and replace or rebuild any worn parts, for a fraction of buying them new again. That, and they carry a lifetime warranty. I'm sorry to hear about your trouble, and hope you get back going soon.