Street Demon Carburetor

625
First hand experience, I just got done bolting one on.
I am on the second carb, the first one had issues.
You have to dissemble the carb to put the chrysler throttle rod on, no big deal, except the carb needs dissembled 10 screws, 2 e-clips no big deal, the instructions are very good and tell you how to do this.
Dumped a small amount of gas in the carb and it fired up and idled.
Sounds really crisp, but have not drove it yet.
I did not adjust anything but the idle screw, (turned it down about 200 rpm)
Tomorrow I will give it a cruise, and see how it runs on the road.
The test vehicle is a stock w-150 with a 318 no modifications.
I really think this is going to be a sweet carb.