my first engine rebuild (318) advises

i dont really know what compression will be. but using KB167 pistons it should be fairly high.
Trying to get good quench and those pistons are looking way to do it.

i will start to calculate compression when i open engine up and i can measure heads cc's and how far down stock pistons are.

i would really want to avoid putting too much cam on my combo.
So i brobably need heavier springs if i put 10200701LK cam?

I really hope my engine is on good shape, machining is really expensive here.
boring one hole is about 100$ and there is 8....
balancing block is about 250$...

Least i can do some basic machining myself.

BTW whats your engine combo, duster rege? looks nice :)