A833 trans alignment issue? Help

It is def in the correct way so it's not hitting.

Update
Found an assistant to work the pedal as I was underneath. First time I was able to spin the clutch about half way around and it hung up. I had them take pressure off the clutch and then press it again. I was then able to spin it about 1/2 way again. Just for giggles I adjusted a little more distance into the clutch rod and it then was able to spin freely. I started the car and it bound up again and was not able to put it in gear.

Bushing. The old bushing was left in when I swapped everything. When I removed the tranny after having this binding problem I noticed a bit chipped off the bushing and noticed that it was not installed flush. It was def catching the tranny shaft. I installed a new brass one and did a good job of it and made sure it was installed flush.

Bell housing. I did remove the bell housing and torqued it to spec