2000 360 engine- put in car or truck? What is needed?

i am currently putting a 5.2L 2001 Dodge ram motor in my 68 Barracuda.There is a thread on this site where someone put the 5.9L (Jeep) in a Dart. Here's what I know so far:
The old motor mount brackets bolt directly onto the Magnum.
You have to switch oil pans. You need The pickup in the back.
The new flex plate will work with minor modifications to one bolt hole.
The old oil filter adapter is compatible.
That's all I know for sure

The motor bolts to the transmission w/ no modification. You will have to grind an access window for the crank sensor.
The new starter is supposed to bolt right up. It should be the new high torque unit.
You will have to modify the dipstick
You will have to install an electric fuel pump for fuel injection. I was told you could install a unit in the gas tank onto the old sending unit. Or. you can go with an external unit. Keep in mind the fuel system is high pressure compared to the old mechanical pump. You also have to add a fuel return to the tank.
You should install a gigantic fuel filter.
I'm prepping my engine compartment for paint and etc., so that's as far as I've gotten. you will need to use the accelerator cable from the donor.
I'm not sure about the trans throttle pressure linkage/cable. Don't know about a speed indicator sensor. Some vehicles have a fuel tank sensor, don't know about that.
The PCM is supposed to be an easy installation. There are some peculiar things that have to be wired into the PCM, but the wiring diagram covers all that. I also was told that the older units OBDI were easier to install, but we have to work with what we got.
The main thing is to remove the under hood wiring harness in one piece.
OK = now that you know that - PIECE of CAKE! You can tell me the rest of the steps!
I plan to wire in the new fuse box and all. There may be a lot of goodies in there. Headlight relays and all that stuff! Good luck and keep us posted. I'll start a thread when I lower the engine in.
Jim