Biohazard

Transmission is pretty much done. The tech said all was good mechanically minus the clutches. They were beginning to "crumble"...lol. All of the seals were dried out and the oil pan was poorly sealed. Whoever sealed up the pan must've been in there doing the bands because they looked like they had recently been replaced. Thumbs up for a legit transmission tech.

Click to expand...

When you go to reassemble engine to trans, take the convertor off the engine flex plate and install it on trans shaft. Before you remove convertor though, mark one flex plate bolt lug to matching nut area on convertor since the bolt pattern is odd spacing. Be sure the convertor is turned and lightly pushed until it seats all way onto shaft. Face of convertor should be about 1/2 inch in from face of bellhousing. Since everything is out probably simpler to install engine & trans as unit.