Driveway Test bed

Depending on the tranny being used on a person,s motor,if it,s a manual car,we install there flywheel and there bell housing and a mini starter.For the auto cars,we use a B&M flex plate and half a converter.Also we use the proper balanced flex plate for cast crank motors,which the owner would provide as they need it any ways.Forged crank motors can go the flex plate route and 1/2 converter or neutral balanced flywheel. Cast crank motors need the proper flywheel balanced to the engine and or flex plate and weighted front half converter,or the proper counter balanced flex plate.Either way we have the parts and start and run the engine and tune it,rejet the carb and time it,look for leaks and repair as needed before install.I will be putting the base together this week with the insulators on the motor plate and the bracket for the two types of tranny,s being used to show a simple way to do this,and cost next to nothing to do,using stuff you have most likely in your garage.Mrmopartech