Yes...Another Subframe Connector Question!
I used 3" x 1.5" x .120" wall (11 gauge) tubing for mine. Notched the rear section to slide over the rails, then used some .120" plate to increase the surface area of the overlap on the rear frame rails.
I put in torque boxes at the same time, and overlapped the connectors at the back when I installed them.
I used 3" x 1.5" x .120" wall (11 gauge) tubing for mine. Notched the rear section to slide over the rails, then used some .120" plate to increase the surface area of the overlap on the rear frame rails.
I put in torque boxes at the same time, and overlapped the connectors at the back when I installed them.
