Would any of y'all recommened or use these on your own engine?

Every set of rocker arms I have ever purchased I've had problems with. PRW, T&D, Harland Sharp, Crane and Hughes. They all need to be carefully inspected before use.

The problem I had with the Hughes was the condition of the rocker shafts. Hughes has their "banana groove" shafts. The grooves on the shafts they sent me looked as if they had been installed with a cutoff wheel on a 4-1/2" grinder. There was proud metal all along the edge of the grooves that would have shaved metal from the rockers and wallowed out the rockers in no time. I had to get out the porting tools and sand the banana grooves to remove the razor blades they had installed when making the banana grooves. Ran them for awhile and then went to the Harland Sharps with their bad adjusting screws and cleanliness issues, but have never reused the Hughes. They sit in boxes waiting for the next time I have geometry or fitment questions.