Disk project or "Thank Gauwd fer power tools" LOL

Got quite a bit done today, just as a rain / thundershower struck. Got one side all done.

Still have to turn the other rotor, pack bearings, and assemble the other side.

When I tore off the drums I bought inverted flare couplings and plugs to cap off the brake tubes.

I used air to blow the caliper pistons out against a 2x4, then filled the caliper with a syringe. Then install the hose, and use a C clamp to retract the piston. The result is a completely bled caliper and hose. You do have to hold the hose "up," LOL

When I put the one side together, pumped the master a few strokes to expand the piston, I had a nice hard pedal with no further bleeding.

"Good Luck" says I on the other side.