Help ignition..here we go again,,,

The lastest ....today I spent a couple hours on wiring issues...I did the "electrical 101'thing today.after I watched the niniers get their butts handed to em.i checked for power at the switch connector. red and brown wire both had power...the red had 12 +volts coming in and the brown had 5.09 volts in run position.. ..at thee outside of the firewall conn there was 5.09 volts at the brown..checked the + at coil and it had 5 volts also...checked the 4 prong resistor and there was 5.0 volts there also...I did some continuity and resistance checking also..i didn't find any wires that were remarkable..except one..very difficult to tell ,but checking the Ign module wire plug one wire caught me ..the yellow and black stripe wire right at the connectorI thot [bit difficult to tell] or I think has a break...I couldn't tell definitively with an ohm meter so I used my meter as a checker with sound..it beeped as I moved it[connector] around it sometimes would stop making beep and as I moved it around it would be very loud and sometimes hardly noticeable ..and sometimes very light sound...the other thing,the schematic shows a four position resistor with a blue jumper on the end that has an open slot for the wire connector to slide into...my schematic says right end brown wire on top..mine is actually brown on bottom..drk green red on bottom mine is actually on top..the same on other end..they are reversed according to schematic...now I checked the resistor...1,5 ohms bottom and 5.8 at the top...is this right or wrong...and which ...thanks for the help ..j