Good 360 Aluminum Head

So I just found out that my old J-Heads are essentially junk, so now I have to buy some new heads, wish I didn't have to but I already spent over 2500 to get my block all prepped, new pistons/rings...I have the entire 360 short-block ready to be assembled, so I'm in this build too far to just stop and continue using my 318 lol. What are some good aluminum heads? eddys? w2? I was thinking about buying some eddys. My only concern is compression, I think you can only buy them with 63 and 65cc combustion chambers, my old heads were 70-72cc I think, anyways I would have had around 10:1 compression with my old heads. I've read that you can handle more compression with aluminum heads, think I can still run a 65cc chamber on 91 fuel? I would think the compression would be just a bit under 11:1 with those heads with my current setup. A guy I talked to said I should be okay, he runs 11:1 on 91 without a problem, just backs timing off a bit.