74 dart swinger, gauge wiring help

Here is part of the diagram showing the gauges

You have to work between the diagram, the index, and the connector layout pages to the rear of the diagrams. Look, example, and the lower right the fuel sender.

"CB9" in the circle is the wire end which fits the sender, and you can look that up in the index, and find a drawing of it in the connector layout.

G4-18DBL is the wire no. G4 an arbitrary no, 18 is the gauge and DBL is the (Dark BLue) color.

Follow up to circle "CB23" and if you look that up, that's the harness connector in the left kick panel

Follow on up to just below the gauge, and there is circled "CI-10" which means Connector, Interior, no 10

THAT IS the round PC board connector. With that wire number (G4-18DBL) go back up one post to the diagram of the connector, and find that wire number which is near top left near the key of the plug.


BACK TO the diagram. Find the voltage limiter and follow the heavy black line to the left again to "CI-10" G5-20DBL. This is your power coming in from the ignition switch, and once again, go to the connector diagram to find which pin.

You can see most of the rest of it layed out right there in the diagram