how does my rocker arm geometry look??

moper said

It looks to me like the valve stems are too "tall". It will run - but it's going to wear the guides and valve stem a lot and it's losing lift because it's not pushing down on the valve, but more over-and-down.
Was there anything done to hose heads in terms of valve job?

Click to expand...

nothing has been done to them since the last time they were gone over and that was about 30,000 miles ago when the 340 they were on was freshened up ....they are the 73 "587" casting j heads they do have comp springs on them. they have been milled some they CC out at 65cc's now other than that they were on a good running 340 i bought a few months ago so i figured i would try to use them...
thanks for the input is there a average valve stem height i can measure for too see if they are in spec?