Starter with TTI's?

I think I used one off an early 2000's Dakota. There's a little spot on the block that's a good idea to clearance to prevent any rubbing issues. It's where there's a large hole in the pan rail. Technically speaking I could bolt my starter in without modificaiton, but it was resting on that spot slightly. A grinder and a minute or two was enough to give me piece of mind. I've had the starter in and out with the headers installed too, no issues. The wiring is a pain to do since the terminals are up high and tight to the block, but to some degree you can put the wires on before you bolt it to the bellhousing for more room to work.