Transgo TF2 Installation A904

Thanks fishy68 for the advice and info on removing "the wall".

I have already grind down the TV valve so it's too late. If I get a problem with the trans not kickingdown, then I have to look for a replacement TV valve and do as you explain.

Here are some pictures of the final installation.








Here are some control measurements to make sure everything is OK. With the throttle lever touching the stop you should have a 3/16 gap between the lever and TV valve. You can use the 3/16 drill which is included in the kit to check the gap.


When the manual lever is all the way out, measure the distance between the manual lever and the pressure adjustment screw. And it should be 1 7/8".


My pressure regulator retainer has a dimple and it can't be set flush as instructions. I adjusted the spring seat until it was equal on both side.


Thanks FABO