Losing my mind trying to get this 360 to run right

Check your plug wire sequence you might have it off a wire,chk plugs,chk timing,chk carb and if you have another one known to be good put it on and see if prob is better or worse,coil backwards it wouldnt run but may be cracked and bad,chk vacuum lines and intake gasket seal,rockers/pushrods,check for a bent pushrod,good ground to engine,dist chk gap.08-.010..cracked cap or loose rotorbug..bad gasket between carb and manifold..stuck valve maybe?If you have another dist try it after setting gap and chkg reluctor for consistantcy[shaft]...pull engine timing up to tdc and chk it against your timing marks versus piston being tdc on #1 cylinder,just some things I would chk on and run down 1 at a time and as a process of elimination,you'll figure it out I'm sure,prob something stupid we've all been there before,pipes would def help as in mufflers,open pipes will pop and crackle...just my 2 cents