Oil pressure-How much is too much?

Wow, that's alot of responce. Lets see, the motor has run for a total of about one hour. It has gone over 200 degrees, because the fans are not adequet. When its hot the pressure was still 75-80 @ idle. I doubt the clearances are too tight, the short block was built by a long time reputable race engine builder and he knew what the application was. I did wiggle the rods and saw that there was side clearance. Just by eye I would say plenty more than .0015. The cam is a COMP Extreme energy XR292 and the COMP specs say the power range is 3500 to 6600. OK with that said, the consensus is that I should take measures to bring the pressure down. Once I get the trans and cooling system sorted out, I'll start by going to a thinner oil. If its still too high, I'll probably trim the pressure spring in the pump. If that fails, I'll ditch the HV pump and go with a regular volume one. If it still too high after that, I'll tear the engine down and invest in a good micrometer set and start checking the clearances. I'm not even going to think about putting my foot in it and reving it up until it's resolved. Thanks to everyone for the input. I'll keep you posted on how I make out.