Will GM 200r4 work with factory floor shift location?

Managed to get a little more work done on the TV/Accel brackets. I already had the TV cable at the location it needs to be. Today I measured the Cuda accelerator linkage distance and it's very close to 5 1/2 inches from the carb pivot bolt/screw to the accel cable bracket/clamp. I had to weld a small triangular piece of metal to the Mopar intake bracket so I could move the Mopar accel bracket/clamp to the right spot. First pic is the Mopar bracket with the small piece of metal tack welded onto it. The second pic is the new Mopar bracket mounted on the intake. Third pic is with the measurement at about 5 1/2" for the Cuda accel linkage.
All the other pics just show all brackets installed even though I need to still do some trimming and welding and paint. The orange GM bracket will need to be trimmed as it sticks too high up above everything else (if you look close you can see a silver line on the top area of the orange bracket where I plan to trim). Also I plan to slot out the holes to give me some minor adjustment (front to back) on the TV mount and the accel mount/clamp. Be careful not to make the attach point for the TV cable too flimsy, if it moves too easily when you stomp on the gas it might give the tranny a false sense of when to shift. I'm probably going to weld a small gusset underneath the orange piece. Should look nice when I'm done.


treblig