I think I got the shaft here

UPDATE: got to looking at the shifter rods that go from the shifter to the tranny. wrong ones. nothing pisses me off more than to try and do a job and not have the right pieces. even more than me getting screwed on the pieces that came with the tranny that are the wrong ones. I figure that was my fault because I did not spend the time to check it out better. so I bought all new rods and rod kit, new z bar, fork rod kit, firewall boot, linkage washers and rubber seals and a new frame ball stud reinforcement brace. Now I believe I have what I need to put it in the car. all except the knowledge to do it. But I am a hard headed old fart. I believe I will eventually get it done. I also bought a couple of new pretties for it. Thanks inertia.