who sells Champion radiators on our site

fishy68 said
Good luck getting a good one for an A-body. The one they sent me not only didn't bolt right in like they said it would, it was warped nearly an inch from one corner to the next. Guess who got to eat $32 to send the piece of garbage back!

cannucky said
I had to waller out the holes in the flange on mine but it works great , overheated my starter a couple of times in the summer heat and humidity but never overheated the motor since I put it in , only bad things about mine are the mopar shrowd won't fit on it and the rad is too thick for my clutch fan with the 70-up water pump , but the extra cooling from the rad more than makes up for losing both of them .

I have one in my Duster from ChallengerGary, great radiator. I did have to drill a new set of holes like Cannucky mentioned, as the original holes in the Champion radiator flange weren't in the right place. But after that I had no problems at all. I have a 26" 3 core in mine with a high volume water pump and it almost cools TOO well. I had to switch back to a standard 195* thermostat to keep things at the right temperature.

Here's a picture with the additional slots I added to the flanges...

And here it is in the car with the old 318 before my 340 swap...