Solid Motor Mounts?

not sure which forum this belongs in so I'll start in small block tech.

I use solid motor mounts in my scamp. I searched and searched and could not for the life of me find solid mounts ANYWHERE and I mean N-E-WHERE! so naturally the old man and I drew up some drafts and settled on 3X3 square steel as the mount itself. and I can honestly say I can feel the power and torque that the rubber in my old mounts was absorbing.

so really my question here is; would anyone here be interested in a set of these? the raw material is a little pricey, but I figured maybe some of those who race and are concerned with squeezing every bit of power out to the wheels would want to check em out. the "prototype" set on my car is about a half inch taller than stock, but we can make stock height as well. these are designed to work with flow tech headers and power steering, as the driver side was hitting the gearbox when the headers were installed.


so... interest, thoughts, criticism, and comments are welcome and appreciated. thanks FABO!