First engine build.

Been pretty busy and have not done much lately. I ended up going with the 1.88" valves. The machinist had time and I did not get back to him about the bigger valves, So he had them done before i got them ordered. My fault, but it will be cheaper.

I finally made some room in the garage and got the block up on the stand. Plan on unwrapping it and starting on it this week. Just wondering what kind of assembly lube to use. I have used lubriplate and redline on motorcycle and small engine. My question is what is best for an engine that might sit a while before being run? Also what is best for wiping down machined surfaces, brake cleaner, lacquer thinner? I thought I read somewhere a member uses coffee filters to wipe down. Any input is appreciated. Hopefully I will have some progress and pictures soon.