Strokers run warmer???

superchargeddrt said

How did you completely empty your cooling system before you installed the Evans waterless coolant? Did you see a big improvement in operating temperature (especially in traffic)? I would like to try this but I wasn't sure how to get all of the water out of my system. Thanks

Click to expand...

You drain the entire system (engine, radiator, heater core) the best you can. I used water to flush the entire system first then I used compressed air to blow the heater core out first (by itself with hoses still attached to heater core but not hooked to engine. Next I did the same to the radiator same way as heater core but applied duck taper around the bottom to make smaller opening, rag up top opening cap on and tight. Last was engine taped off/blocked off all but water pump opening and blew air through heater hose connection. After that you use a product from Evans coolant that takes the rest of the water out of the system. When that is all done, I poured in Evans coolant and no more worries.