What do you think?

Yeah. I have a new set of Dougs headers, but I have decided not to use them. I just don't want the hassle. I am getting too damn old to have to worry about crawlin under it replacing this gasket and that. I want something that will LAST. I've had headers on damn near everything. I just don't want them anymore. Thanks for the input. Remember though, that advertised compression ratio was just that. I am talking about an actual blueprinted compression ratio. The block has been zero decked. The heads will be addressed to get compression right around 10.4......or less if I can do it. I know I will be close to pump gas compression limits, especially since I am not using the close chamber heads for quench. I've done the dynamic calculations and I will be under 8:1 at a static 10.4 with the 528 cam, so I should be ok.