Making molds of a part or 2

ok! :cheers:A few tweaks (sanding bad spots that showed &%^&$&) and I can officially say the drivers side mold is DONE! and ready to make parts.
here's what it looks like in my 66 dart with the dash board off for a better view
cutting it out is a Bear! I really gotta learn how to cut it out like the pro's do.
View attachment DSCF4434.JPG

a little oops and I took a chunk off the bottom edge &*(&^*
View attachment DSCF4435.JPG


dang I can seem to catch a break, drilled the holes wrong too! luckily a bigger bit fixed it! so I could shift it into position. I'll change that on the drawing and mold so it doesn't happen pn the passengers side.
View attachment DSCF4432.JPG


shifted the hole a bit to actually match the door windlace. Whew.
View attachment DSCF4433.JPG

Added the speaker to check things out.
View attachment DSCF4436.JPG

yup it'll stil clear the dimmer switch! NICE!!!
View attachment DSCF4437.JPG



and it doesn't come close to the fresh air door! yeah I'm good to go!
View attachment DSCF4438.JPG