Making molds of a part or 2

this is what they look like after I gave them a bath to clean the dirt off and trim up loose ends.
View attachment 103_1274.JPG
corners are rounded off to make them
View attachment 103_1276.JPG
gonna try a flat rate box and see if they fit in one of them.
View attachment 103_1279.JPG

here is the slots on the dart so you have a LOT of leway to mount them

View attachment slots for the kick panel.jpg

these parts fit the 63-66 dodge dart and plymouth valiants. probably the early cudas too (gonna have to check with Waggin to make sure, so don't hold me to it.) they fit 3 inch deep 5 1/4 speakers there is 3 14 inch space behind the panel so that the speaker does not hit metal.
1. they clear the fresh air doors on both sides.
2. they have the locator holes made about .2 and can be slotted for different cars with thicker carpet. the 4 door, the v8 convertible and my /6 ALL had slightly different screw locations since the slots that the screws went into were slotted up and down. a little less that 7/16 long.
3. the bottom kickout part that was added for stiffness and to help keep dirt out of the carpet edges can be trimmed up to 3/8th of an inch without loosing any stiffness and "looks" for those with well insulated and thicker carpets. (just score it (heavily in the peak if the curve and it'll break in that area. or just sand it down)
4. edges have been molded in with a soft edge and CNC cut(you really,really don't want to see my hand cut ones. think 400 lb fat lady that lost 300lbs,yeah that bad.)
5. made out of rot proof and crack resistant .125 ABS haircell plastic.

I've already got some sets promised and am waiting on some more abs to be shipped to the house. 84.00 + shipping for those here on forabodiesonly.