Granny's QA1 k-member install

I have been reading the "new QA1 k frame thread, and I have so far had the same problem as garyfish 340 with one of the torsion bars (the driver's side) not seating all the way. I am very close, a 1/16" would allow me to install the retaining clip. I have a set of Firm Feel's torsion bars. I will call them and ask them about sanding down the bar a bit. Heck, removing the powder coating
might be enough for mine to seat. I have also been wondering about difference in diameter between the front mounting sleeve in the k member and the supplied bolt. If you used a bushing to take up the space, you might lose any adjustability. I did notice that the tubular K member manufactured by Magnum Force racecar fab also appeared to use the same tube and bolt system.